P180BUser’s ManualManuel de l’utilisateurAnwenderhandbuchManuale per l’operatoreManual del usuarioপᡅ䂀ᯢ
1At Antec, we continually refine and improve our products to ensure the highest quality. So it’s possible that your new case may differ slightly from
26. Place your motherboard on the brass standoffs.7. Screw in your motherboard to the standoffs with the provided Philips-head screws. Your motherboa
3Note: Please check your motherboard manual for your IEEE 1394 header pin layout and make sure it matches the attached table. If you intend to connect
43. There are two HDD trays inside the cage. Squeeze the metal clips on each side of a tray and slide it out.4. Mount your hard drive to the drive tra
55. Please refer to the power supply installation section, to route the power cables to your devices. Once you’ve done so, connect the appropriate pow
6These two fans are mounted so that the air is blowing out of the case. The top fan comes with a spoiler to mount on the top of the case.To install th
7The Optional Fans There are two optional 120mm fan mounts — the front fan (located in front of the upper HDD cage) and the middle fan (located inside
Antec, Inc.47900 Fremont Blvd.Fremont, CA 94538USAtel: 510-770-1200fax: 510-770-1288Antec Europe B.V.Stuttgartstraat 123047 AS RotterdamThe Netherland
Comments to this Manuals