Antec GX700 User Manual

1 GX700 User Manual

10 GX700 User Manual 2.1 Setting Up Put the case upright on a flat, stable surface so that the rear panel (power supply and expansion slots) is

11 2.2 Removing the Front Bezel You may need to remove the front bezel in order to install fans. To remove the bezel, place your hand in the n

12 The GX700 comes with motherboard standoffs (B in section 1.3). These are meant to be positioned for Standard ATX, microATX or Mini-ITX motherboar

13 2.4 Power Supply Installation 1. With the case upright, place the power supply in the case and align the rear of the unit with the mounting

14 Remove the metal drive bay cover 2.5 External 5.25” Device Installation 1. Remove the metal drive bay cover by unlocking the click-on clasp

15 Align and lock the drive bay tab on either side 3. Slide your 5.25” drive through the front of the chassis until it lines up flush with the fron

16 2.6 Internal 3.5” Device Installation The GX700 includes 5 drive holders. You will need one for each 3.5” drive. 1. Insert three pins on t

17 2.7 Internal 2.5” Device Installation Each of the five 3.5” drive bays also support 2.5” drives: 1. Align your 2.5” drive with the holes

18 Use the grommet-lined cable routing holes to route PSU cables. 2.8 Cable Management There is a cable management compartment bet

19 Section 3 Cooling System

2 GX700 User Manual Congratulations on your purchase of the GX700! The new flagship in Antec’s GX series, the GX700 is ready to take your system

20 GX700 User Manual 3.1 Included Fans The GX700 comes with two standard 140 mm fans and a rear 120 mm fan (yellow outline). The red rectang

21 Slide the fan behind the front plate Align both fans and screw them in 3.2 Optional Fans The GX700 includes mounts for up to three more fan

22 Side 120 mm fans On the side panel, there is one mount for a 120 mm intake fan. 1. Align your fan with the screw holes. The fan should be inst

23 To remove the front air filter: 1. Remove the four thumbscrews and metal filter panel 2. Push down on the tab on the filter and pull it a

24 The GX700 features a removable PSU filter. To remove the PSU filter: Remove the filter by pulling the tab toward you using the tab outside th

25 Antec, Inc. 47900 Fremont Blvd. Fremont, CA94538 tel: 510-770-1200 fax: 510-770-1288 Antec Europe B.V. Stuttgartstraat 12 3047 AS Rotterd

3 Table of Contents Section 1: Introduction 1.1 Getting to Know Your Chassis ...

4 Section 1 Introduction

5 GX700 User Manual 1.1 Getting to Know Your Chassis

6 *The top dive bay of the GX700 is only meant for controls 1.2 Chassis Specifications Chassis Type Mid-Tower Chassis Color Military Green /

7 1.3 Included Screws An inventory of all screws and intended usage and quantity is provided here: A. PSU screws B. Motherboard standoffs

8 1.4 Before You Begin In order to ensure that your building experience with the GX700 will be a positive one, please take note of the followi

9 Section 2 Hardware Installation