1
Put the case upright on a flat, stable surface so that the rear panel (power supply and expansion slots) is facing you. To remove the left and right
The P280 comes with six preinstalled motherboard standoffs. These are positioned for Standard ATX motherboards but can be relocated to accommodate oth
The following instructs how to install the Antec KUHLER H2O liquid CPU cooler (620 / 920). For any other CPU coolers, please consult your manufacture
3. Preparing the KUHLER H2O backplate is specific to your CPU socket. Please refer to the KUHLER H2O installation guide, available at http://www.ante
To install a 5.25” drive, you will need to remove the side panel and open the front door. For side panel removal, please see Section 2.1. 1. With th
There are two dedicated 2.5” drive bays in the P280. To install a 2.5” drive: 1. With the side panel open, slide your 2.5” drive into th
To install a 2.5” drive: 1. Extract one of the drive trays by pinching the ends of the tray inward and pulling the drive tray out. 2. 2. Place your
There is a cable management compartment between the motherboard and right side panel, as well as cable tie downs located on the back of the
Connect the front I/O panel USB cable to the USB header pin on your motherboard. Check your motherboard user’s manual to ensure that it matches the t
Model P280 P280 Window P280 White P280 White Window Color Finish (interior) Black Black White White Color Finish (exterior) Black Black
There is an Intel® standard 10-pin AC’97 connector and an Intel® 10-pin HDA (High Definition Audio) connector linked to the front panel o
There may come a time when you need to reconfigure the pin-out of a motherboard header connector. Examples could be for your USB header, audio input
The P280 comes with two standard top 120 mm TwoCool™ fans and a standard rear 120 mm TwoCool™ fan. These fans have two-speed switches on the rear of
Internal intake 120 mm fans Just outside of the 3.5” drive bay area are two fan mounts for 120 mm internal intake fans. 1. Align your fan wit
There are two filters in the P280 that can be removed and washed. One filter is the front filter and the other is the PSU intake filter. You can acce
Antec, Inc. 47900 Fremont Blvd. Fremont, CA94538 tel: 510-770-1200 fax: 510-770-1288 Antec Europe B.V. Stuttgartstraat 12 3047 AS Rotterdam The Nethe
P280 User Manual Congratulations on your purchase of the Antec P280! Sophisticated and cutting-edge, the P280 emphasizes the ease of use, quiet
Section 1: Introduction 1.1 Getting to Know Your Chassis ... 6
1. 3 x 5.25” tool-less drive bays 2. 2 x 2.5” drive trays (dedicated) 3. 6 x 3.5” / 2.5” drive trays
Chassis Type Super Mid-Tower Chassis Color Black with aluminum door Dimensions 20.7” (H) x 9.1” (W) x 22.1” (D) 526 mm (H) x 231 mm (W) x 562 mm (D)
In order to ensure that your building experience with the P280 will be a positive one, please take note of the following: While working inside you
Comments to this Manuals