Antec II User Manual

OVERTURE IIUser’s Manual

2At Antec, we continually refine and improve our products to ensure the highest quality. So it'spossible that your new case may differ slightly f

35. Screw the brass standoffs into the threaded holes that line up with your motherboard. Do not overtighten the standoffs. Some standoffs may be pre-

CONNECTING THE IEEE 1394 (FIREWIRE®, I.LINK®) PORTYou will find a single 10-pin connector on a cable attached to the front IEEE 1394 connection.This i

56. Rear Right Speaker Out Pin: Connect the RET-R connector to this pin.7. Rear Left Speaker Out Pin: Connect RET-L connector to this pin.INSTALLING 3

or Low to a fan-control device may result in the fan not being able to start. The already loweredvoltage from the fan control device will be further r

7Overture II - Explorer Description12a2b367891011121314151617185419NoDescriptions1Top Panel with Ventilation2aNormal Expansion Slot Cover2bVentilated

Antec, Inc.47900 Fremont Blvd.Fremont, CA 94538Tel: 510-770-1200Fax: 510-770-1288Antec Europe B.V.Sydneystraat 333047 BP RotterdamThe NetherlandsTel: