Antec SOLO II User Manual download pdf (Page 6)

The Suspension Mount

This is the ultimate hard disk mounting solution to reduce the hard drive noise.

There are three sets of Suspenders inside the cage to mount three hard drives.

Each hard drive needs two Suspenders (front and rear) to mount it. Note: please

DO NOT transport your system with your hard disks in mounted suspension. The

drives may slip from the Suspenders and damage the hard drives and other

components inside the case.

1. Remove the trays from the cages. Store them in a safe place.

You won’t need them now.

2. Insert the hard drive through the front Suspender from the

front. See picture 1.

3. Adjust the hard drive position so it has at least 10mm

clearance from the front 92 mm fan (fan not included).

See picture 2.

4. Find a 4-pin Molex connector on the power supply and

connect it to the male 4-pin connector on the device.

5. Repeat the same procedure for the other drives as

necessary.

6. Put the front fan cage back to the case. If you plan to

mount the optional 92 mm case fans, do it now. See the

Cooling section for fan installation

5.25” Device Installation

There are four external 5.25” drive bays (one with 5.25” to 3.5” Adapter).

Carefully remove the metal plate covering the drive bay you wish to use.

1. Take two plastic drive rails and mount them to the sides of the 5.25” device.

Make sure to align the front set of the screw holes for the devices. Also make

sure the end of the drive rail is angled away from the device and facing forward.

2. Slide the device into the drive bay until you hear a click.

3. Mount the other devices accordingly.

4. Connect a large 4-pin connector from the power supply to the male 4-pin

connector on each of the devices.

To install a floppy or other external 3.5” device to the 5.25” to 3.5” Adapter:

1. Slide the Adapter out.

2. Place the drive to the Adapter and fasten the drive with screws provided.

3. Find a 4-pin floppy power connector on the power supply and connect it to the

male 4-pin connector on the devices.

Picture 1

Picture 2

1 2 3 4 5 6 7 8

No comments

Antec SOLO II User Manual Page 6