Antec GX300 Window User Manual download pdf (Page 13)

2.4 Internal 3.5” / 2.5” Device Installation

The GX300 Window has six drive bays that are compatible with both 3.5” and 2.5” drives.

To install a 3.5” drive:

1. Remove one of the drive trays by pinching the ends of the tray inward and pulling the drive tray

out.

2. Place your 3.5” drive on the tray so that the holes line up with the silicone grommets.

3. Using the 3.5” drive screws (F in Section 1.3), secure your 3.5” drive to the tray. We recommend

using your hand to find the exact threading of the drive’s holes then using a screwdriver to

completely secure your drive. Do not over-tighten the screws as this will minimize the

grommets’ ability to reduce vibration.

4. Now that your drive is secured to the tray, pinch the ends of the tray and insert your drive

into the bay. You will hear your device click into place.

Use your hand to find the drive’s holes.

Screw in the holes to secure your drive.

Pinch the ends of the tray and insert your drive until

it clicks.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

No comments

Antec GX300 Window User Manual Page 13